Rebar Straightener Machine

The rebar straightener machine is one of the steel bar processing machines. It is used to straighten and cut steel bars with a diameter of less than 14 mm. The cutting length can be customized according to customer requirements. It can be adjusted to straighten and cut stainless steel wire, aluminum wire, cold-drawn wire, plastic-coated steel wire, etc., with neat cuts, small errors, and good performance.

It has the characteristics of a reasonable structure and convenient, safe, and reliable operation. It is suitable for straightening chicken cages, rabbit cages, construction mesh, various welding wires, board wire cutting, and special-shaped mesh wires.

The structure is that the high-speed rotor rotates to adjust the angle of the straightening die to achieve the straightening effect, and then the threading wheel spins the thread forward. After reaching the required size, the wire touches the positioning key and advances the runway 5 mm. The upper punch presses the vertical wire cutter and cuts it immediately. The wire presses the opening bearing through the pressure plate on the vertical wire cutter, and the wire automatically falls to the wire support, if you want to change the length, move the positioning key.

1. The installation of the machinery must be stable and maintain a horizontal position. The motor should be well grounded and rainproof measures should be taken when it is in the open air.
2. When processing long steel bars, help should be provided, and the operator's instructions should be followed. Do not push or pull at will.
3. The material rack and material trough should be installed straight and aligned with the center line of the guide tube, straightening tube, and cutter hole.
4. Used to rotate the flywheel, check the rotating mechanism and working device, adjust the gap, tighten the bolts, and after confirming that it is normal, start the idling operation, check that the bearings should have no abnormal noise, and the gear teeth should be in good condition. The operation can only be performed after far rotation.
5. Select the appropriate straightening speed and rotation speed according to the diameter of the straightening steel bar. Do not feed materials until the straightening block is fixed and the protective cover is closed. It is strictly prohibited to open each protective cover or adjust the gap during operation.
6. After the steel bars are fed in, a certain distance must be maintained between the retractor and the tug wheel and must not be approached.
7. Before feeding, the uneven material head should be cut off, and a one-meter-long steel pipe should be installed in front of the guide tube.
8. After the operation, the straightening block of the straightening cylinder should be double-opened and returned to its original position. At the same time, the preload spring must be returned to its original position.