Practical operation method of sandblasting machine

Mar 07, 2024

Leave a message

The sandblasting machine connects the filled liquid nitrogen cylinder with the equipment, opens the valve to check whether the pipeline is leaking, connects the power supply, and the power indicator lights up. Push open the arc door, press the "inch" button, roll the drum until the drum cover is facing up, remove the lever and the drum cover, load the product to be repaired, add an appropriate amount of steel balls according to the process table, cover the drum cover, press the lever, and pull down the arc door in place. Set the freezing operation temperature, drum speed and duration, adjust the liquid nitrogen supply and timing switch to automatic, press the "start" button, the drum starts to roll at 5 rpm/s, the liquid nitrogen starts to be automatically supplied, the drum begins to cool down when the temperature of the burr machine drops to the set temperature, the drum rotates rapidly, and the supply and interception of liquid nitrogen are controlled by the temperature controller, and the switch is automatically powered off and the drum stops tumbling at the set operation time.
The sandblasting machine pushes open the arc door, removes the lever and the drum cover, presses the "jog" switch, waits for the product and the steel ball to fall into the net, presses the "pick" button, separates the product and the steel ball, and loads the product into the designated container, cleans and cools to prevent the waste of liquid nitrogen. After the burr machine is used up, it is necessary to clean and clean, pay attention to the abnormal working dynamics of the equipment during the operation, and refuel the moist parts of the equipment on time. The burr machine should be operated by a special person, and if there is an abnormal situation, please repair it by professionals, and it shall not be disassembled without permission.