Influencing Factors in All Aspects Of The Sandblasting Machine

May 05, 2024

Leave a message

1. Effect of abrasive type on surface results

Abrasives are classified into spherical and diamond-shaped according to the state of the particles. Corundum is commonly used for sandblasting (white steel jade) brown corundum) is a diamond-shaped abrasive. Glass beads are spherical abrasives. After the P.H.θ three values are set, the spherical abrasive sandblasting surface is smooth, the diamond abrasive surface is relatively rough, the same abrasive thickness, according to the number of sieves in China, generally called how much, the higher the quantity, the smaller the particle size, after the P.H.θ setting value, the higher the number of sandblasting of the same abrasive, the smoother the surface result.

2. Adjust the effect of pressure on the surface result S.H.θ After setting three quantities, the larger the P value, the higher the jet flow velocity, the higher the sandblasting efficiency, the rougher the surface of the workpiece, on the contrary, the surface is relatively smooth.

3. The distance of the spray gun, the influence of angle change on the surface result after the P.S set value, which is the key to manual sandblasting technology, the distance of the spray gun from the workpiece is generally 50~150mm, the farther the spray gun is from the workpiece, the lower the jet flow efficiency, and the smoother the surface of the workpiece. The smaller the angle between the gun and the workpiece, the lower the spraying efficiency and the smoother the surface of the workpiece.